PE Stamp and License Verification in Michigan

These links are provided as starting points to the official state sources. A board's current instructions and online record control; confirm the page, status, discipline, and authorization directly before a project submission.

• Michigan engineering licensing board
• Official license verification or lookup
• Project code and AHJ requirements for Michigan
• Responsible engineer and scope confirmation

The Michigan board resource does not approve a design or transfer responsibility to a contractor, owner, or another engineer. The responsible professional reviews the project inputs, code basis, calculations, drawings, and existing conditions, then determines which documents can be signed or sealed. Michigan enforces a statewide, mandatory commercial building code adopted by the Bureau of Construction Codes under LARA. The state has historically run a cycle or two behind the model code — the commercial building code is based on the 2015 IBC — so designers should confirm the current adopted edition and any pending updates with the AHJ. Michigan grants licensure by comity for NCEES-record engineers; electronic seals and digital signatures are accepted for permit submittals under board rules.

A Michigan PE may need the project address, current architectural backgrounds, discipline scope, adopted code information, site and existing-condition evidence, equipment data, calculations, AHJ checklist, and any correction notice. Michigan's Bureau of Construction Codes sets the statewide baseline, while local building departments and, in some areas, state plan review handle commercial permits. Detroit and Grand Rapids run structured commercial review; because the state code edition lags the model cycle, aligning submittals to the actual adopted edition avoids comment cycles. Severe lake-effect snow along the western and northern shorelines; Very cold winters, with the U.P. reaching climate zones 6A and 7; Long heating seasons that dominate mechanical energy use; Humid summers requiring dehumidification and condensation control are examples of why project inputs must be confirmed rather than assumed.