Is an Engineer Required for a Metal Building in Tennessee?

Tennessee jurisdictions — Nashville, Memphis, Knoxville, Chattanooga — require an engineer-sealed plan set for commercial and industrial metal buildings, and the PE seal is the standard requirement for the foundation and site-specific structural sheets. The seal must show the engineer's name, Tennessee PE number, and date, with the engineer in responsible charge. The manufacturer supplies PE-sealed drawings for the building itself — the rigid frames, purlins, and girts — but the foundations, site-specific load verification, and the permit set are designed and sealed by the Tennessee engineer of record. Owner-builders don't escape the requirement: the building department asks for the seal regardless of who drew the plans, and the engineer must verify the building for New Madrid seismic risk and tornado wind.

The engineer designs the foundations for foundations for seismic column reactions in Memphis — the engineer details deep piers and anchor bolts for New Madrid earthquake overturning, and verifies the rigid frames for rigid frames with seismic bracing plus tornado-wind checks — the engineer designs the lateral system for earthquake forces and high-wind uplift together. Purlins, girts, eave struts, and rod bracing go on the sealed plan set — member sizing for gravity and lateral loads, bracing layouts, and the anchor-bolt detailing that ties the building to foundations designed for New Madrid seismic risk and tornado wind. Bring the manufacturer's anchor-bolt plan and column reactions, a geotechnical report for the lot, and the building dimensions and eave height. The engineer designs the lateral system for earthquake forces and high-wind uplift together — New Madrid seismic plus tornado wind.

Use this checklist before engaging an engineer for your metal building: • Engineer of record holds an active Tennessee PE license, verifiable on the state roster • Foundations designed for the manufacturer's anchor-bolt reactions against New Madrid seismic risk and tornado wind • Rigid frames, purlins, and girts verified for New Madrid seismic risk and tornado wind per ASCE 7 • Rod bracing or portal-frame lateral system detailed on the sealed set • Anchor bolts, base plates, and hairpin ties detailed for uplift and overturning • Eave height, clear span, and bay spacing called out and checked • Geotechnical report reviewed before foundation design • Engineer confirms they'll respond to plan-check corrections on sealed sheets