Can I Get a PE Stamp for My Existing Home Plans in Kansas?

Kansas requires the sealing engineer to be in responsible charge of the engineering — the engineer must have exercised engineering judgment over the design. For existing plans, this means independent verification: the engineer recalculates structural elements, checks code compliance under the applicable Kansas-adopted codes, and revises the drawings as needed before sealing. The seal must show the engineer's name, Kansas PE number, and date. Kansas engineers cannot seal work outside their area of competence. Wichita, Overland Park, Kansas City, and the other municipalities review the sealed package.

The review starts with the full drawing set: architectural, structural, foundation, and any prior calculations. The engineer checks the design against the design loads — wind on the open plains, expansive clays — verifies foundation design per the geotechnical report, and recalculates beams, columns, foundations, and the lateral system. Frost protection is checked. Deficiencies get redlined; the drawings are revised until the engineer can take professional responsibility. Bring the geotechnical report, the design criteria, and any prior plan-check comments. Incomplete documentation is the biggest delay.

Use this checklist before engaging an engineer for existing plans: • Engineer of record holds an active Kansas PE license, verifiable on the state roster • Plans are complete: architectural, structural, foundation, and prior calculations • Frost-depth compliance verified for footings, plumbing, and equipment • Geotechnical report addresses expansive clay for the specific site • Prior plan-check comments included so corrections aren't repeated • Engineer confirms they'll respond to plan-check corrections on sealed sheets • Scope agreement covers review, revision, sealing, and corrections • Seal shows name, Kansas PE number, and date on every sealed sheet