Can I Get a PE Stamp for My Existing Home Plans in Idaho?

Idaho requires the sealing engineer to be in responsible charge of the engineering — the engineer must have exercised engineering judgment over the design. For existing plans, this means independent verification: the engineer recalculates structural elements, checks code compliance under the applicable Idaho-adopted codes, and revises the drawings as needed before sealing. The seal must show the engineer's name, Idaho PE number, and date. Idaho engineers cannot seal work outside their area of competence. Boise, Meridian, Nampa, and Idaho Falls review the sealed package.

The review starts with the full drawing set: architectural, structural, foundation, and any prior calculations. The engineer checks the design against the design loads — Idaho's frost depth, snow, and seismic demand are the signature issues — verifies foundation design per the geotechnical report, and recalculates beams, columns, foundations, and the lateral system. High-country snow is checked for the specific site. Deficiencies get redlined; the drawings are revised until the engineer can take professional responsibility. Bring the geotechnical report, the design criteria, and any prior plan-check comments. Snow-load and seismic errors are the items most existing plans miss.

Use this checklist before engaging an engineer for existing plans: • Engineer of record holds an active Idaho PE license, verifiable on the state roster • Plans are complete: architectural, structural, foundation, and prior calculations • Snow loads match the site elevation • Frost-depth compliance verified for footings, plumbing, and equipment • Geotechnical report addresses local soils for the specific site • Prior plan-check comments included so corrections aren't repeated • Engineer confirms they'll respond to plan-check corrections on sealed sheets • Seal shows name, Idaho PE number, and date on every sealed sheet